close
close

How To Install Sharkbite Fittings On Existing Copper Pipe

How To Install Sharkbite Fittings On Existing Copper Pipe. Slightly turning the line, push the pipe in the fitting until it reaches the tube stop. Just slide the fittingon to the pipe and slip the fittingback to make the connection.

How To Install Sharkbite Fittings On Old Copper Pipe
How To Install Sharkbite Fittings On Old Copper Pipe from hooverdust.com

Position the pipe side prong so it's fully seated on the pipe. The sharkbite fitting must push all the way to the line. Now use a repair coupling (has no pipe stops inside it).

Today I'm Going To Show You How I Used Sharkbite Fittings To Save Some.

When installing sharkbite fittings always measure and mark any copper pipe that the sharkbite fitting will be sliding onto. Apollopex barb fittings are a key component of the most economical potable water. Inspect and clean the end of the pipeand the fitting.installthe new copperpipeinto the standard coupling and then slide the slip coupling onto the other end of the pipe.installthe pipeagain, making sure to fully seat the pipe into the sharkbitefitting.

Avoid Jagged Ends With Burrs.

Be sure the pipe is free of scratches or debris and cut the pipe as cleanly and squarely as possible.measure & mark the insertion depth. Sharkbite fittings can be used on both hot and cold water lines.sharkbite fittings work well with pex, cpvc, and hard drawn copper.sharkbite universal fittings have a maximum temperature of 200°f maximum pressure 200. In order to connect the new sharkbite shutoff valve to the old copper pipe, use a sharkbite slip end fitting.

Insert Copper Pipe In The Suitable Sharkbite Fitting.

Slide it completely onto the pipe, install the short piece, then center the coupling over the joint. Place the fitting side above the barrel of the sharkbite fitting. Just slide the fittingon to the pipe and slip the fittingback to make the connection.

Squeeze The Handle To Compress The Release Collar, Which Is What Makes The Fitting Let Go Of The Pipe.

Position the pipe side prong so it's fully seated on the pipe. Shorten the piece you cut so it fits the left over spot. No soldering clamps unions glue or special tools required.

The Sharkbite Fitting Must Push All The Way To The Line.

Take a piece of copper pipe and slide it all the way into the safe seal depth and pipe deburring tool. Replacing copper pipes and fittings with sharkbite push fit connectors is super easy. Now to join the fittings, the following steps are to be done.

Leave a Reply